|
|
 |
|
| |
Wideband receiver with
dualwatch capability
The IC-91AD/A has dualwatch receiver capability, allowing you to
receive* two bands simultaneously (including same band). By
pushing and holding the [Main/Dual] button, you can easily turn
dualwatch on and off, while a press of the button allows you to
toggle the active VFO channels.
* See specifications for receive range coverage.
Large dot-matrix LCD
Using a large full dot-matrix LCD (37.8~20 mm; 11/2~25/32 in),
the IC-91AD/A clearly shows two-line frequency settings,
alphanumeric channel name, bandscope, etc. You can choose large
or small font size in the setting mode. In addition, automatic
LCD and keypad backlighting provides bright illumination for
night time operation.
5 Watts (typical)
output with Lithium-Ion technology
Icomfs original wideband PA circuit and supplied lithium-ion
battery pack provides 5W (typ.) output. The supplied BP-217
provides up to 5/4.5 hours* of operating time and greatly
reduces both the size and weight needed to obtain full output
power.
* VHF/UHF single mode, Tx high: Rx: Stand-by duty ratio= 1: 1: 8
Simple bandscope
Spectrum activity is displayed on the screen and audio is heard
while sweeping the range. It is useful for finding new or
interfering signals.
Keypad navigation
The 4 cursor direction buttons on the keypad gives you quick and
intuitive access to many settings. The twin volume/channel knob
provides convenient channel/volume setting.
External DC power jack
An external DC power jack allows for operation with an external
DC power supply (10-16V DC). When used with the CP-19 or
OPC-254L, simultaneous operation during charging is possible.
Built-in CTCSS/DCS Encoder and Decoder
CTCSS and DCS tones are used for accessing a repeater or for
tone squelch operation. The pocket beep alerts you with a beep
sound when the transceiver receives a preset tone.
Other features
- Squelch
release function to monitor a weak signal.
-
Water-resistant construction, equivalent to IPX4
- Auto
power save, power off and power on
- 26
memory banks with selected bank and bank link scanning
- 10
channel DTMF memory (16-digit)
- 10dB
(approx) built-in attenuator
- Total
of 1304 memory channels
-
Automatic repeater function ( USA version only)
- Weather
channel with weather alert ( USA version only)
|
|
| |
| |
|
|
| |
D-STAR(IC-91AD)
Advanced digital technology in your hand now!
|
|
| |
|
|
| |
 D-STAR
DV mode available (Digital Voice + data)
The IC-91AD* provides DV mode operation with an AMBE
codec. 950 bps data can be sent simultaneously with the
digital voice transmission. When you receive an FM mode
(or other mode) signal while operating in DV mode, the
automatic DV detection function changes the operating
mode to the one detected.
* Optional UT-121 is required for use with IC-91A.
One touch reply button
The newly adopted one-touch reply [CALLRX->CS]button
memorizes the received callsign(s) at the touch of the
button. This function allows you to respond to the
calling station without hassle. In addition, up to 20
received callsigns are stored in a received call
history.
Built-in voice recorder and auto reply function
The built-in voice recorder* records an incoming call
for up to 30-seconds(approx.), (or 15 sec. x2 tracks, 10
sec. x3 tracks).The 10 sec. Transmit memory allows you
to record your callsign, CQ and automatically answers
when you receive a message.
* Available in DV mode only
Optional PC remote control capability
When connected to a PC via an RS-232C cable, most
functions of theIC-91AD/A* can be controlled from the PC
with the optional RS-91 soft-ware. In DV mode operation,
you can send and receive short messagesof 20 characters
(Max.) on the PC. (* Also available in analog mode)
Position information exchange
When connected to an external GPS receiver (NMEA0183
format), your own and other station's position
information can be sent and received*.The IC-91AD sends
the position data either by holding the PTT switch, or
at a preset interval (5 sec.-30 min.), depending on the
setting.
* GPS data receive only when no external GPS receiver is
attached.
DX communication over the D-STAR system
The D-STAR repeaters for 144, 440MHz are now available.
It allows cross band (144/440/1200MHz)operation and long
distance communication over the D-STAR system. |
|
|
|
|
| |
|
|
|
|
|
|
